Join Date: Apr 2013. Posts: 7. dpf removal without an ECU remap. Hi, i recently bought a 08 mazda3 1.6d takara and within 6 weeks the dpf was was totally blocked and the car pretty much shut down (cut out after 1500rpm) and the 2 pipes with pressure sensors blew. So, my mechanic removed the dpf honeycomb with hammer and chisel, put the dpf back The Diesel Particulate Filter [DPF] will be a problem with all makes and models until the manufacturers get the mechanics of DPF sorted just like they had to with the catalytic exhaust system when they were introduced. The latest Colorado, Ford Ranger, Mazda BT50, have the device. The Ford and Mazda have a recall notice on their DPF due to fire. Hi. I'm new to forum. I have a mazda 6 2009 2.0d sport with fsh and 133k miles. I've owned the car from 39k miles and often travel on motorways. A few months back I had a flashing dpf light and shortly afterwards engine management light and limp mode. 4. Release the accelerator pedal while the CEL is still blinking. 5. Wait 10 second. 6. Depressthe accelerator pedal in full and hold it for 10 seconds or more. 7. Fully release the accelerator pedal while the CEL light keeps flashing. 8. Turn the ignition switch to “OFF” position and start the vehicle. Some of the following symptoms are signs of a blocked DPF filter on your Mazda: Limp Mode / Loss Of Power; DPF Warning Light On; Engine Management Light On (EML / MIL) Poor Fuel Consumption; Glow Plug Light Flashing; These faults can cost in the region on £1000+ to repair if not dealt with as soon as possible. The DPF will undergo passive and active regeneration, as you drive. If the DPF is starting to fill up, just give it a clean (don’t wait till the ash plugs are impacted, the DPF light is flashing, and your stuck in limp mode), reset, and continue enjoying your car!!! 🙂👍 Happy Days Bro. BT9na8. The Diesel Particulate Filter [DPF] will be a problem with all makes and models until the manufacturers get the mechanics of DPF sorted just like they had to with the catalytic exhaust system when they were introduced. The latest Colorado, Ford Ranger, Mazda BT50, have the device. The Ford and Mazda have a recall notice on their DPF due to fire. Repair steps: Connect the DrivePro device and then read out the DTC for the engine. If the code P1336 is set and the DPF light is flashing while the engine is running, you should check timing chain as described below. Next, remove the valve cover. Once this has been removed, the timing chain, camshaft gears and valve train will be exposed. aust_norm said: They checked it out and apparently there is a bulletin out from Subaru Australia advising of the issue which is someting called " oil dilution ". The fix is to drain the oil (I assume it was engine oil) and reset the DPF sensor. All up a 15 to 20 minute job that was done for free. Norm. 2009 mazda 6, Partikelfilter problem. Hej allesammen. Vi var i dag på vej hjem fra jylland (bor i nordsjælland), da vi skulle ind og tanke. Da vi skulle køre igen, sagde bilen at der var problemmer med partikkelfilteret, og at vi skulle køre på værksted hurtigts mulig. Vi valgte dog at køre hele vejen hjem, og ud over at lampen til Join Date: Apr 2013. Posts: 7. dpf removal without an ECU remap. Hi, i recently bought a 08 mazda3 1.6d takara and within 6 weeks the dpf was was totally blocked and the car pretty much shut down (cut out after 1500rpm) and the 2 pipes with pressure sensors blew. So, my mechanic removed the dpf honeycomb with hammer and chisel, put the dpf back Dnes som dával vymenit olej pretože mi blikalo dpf na palubovke, všade som sa dočítal že by to mala byt. kontrolka signalizujúca interval výmeny oleja. Na oleji som mal najazdené cca 8000km ale pre istotu som už dal vymenit.

mazda 6 dpf light flashing reset